E-Z-ON PRO Products
Product Details
- Transforms seats with only lap belts to 4-point securements.
- Grows with the passenger through the never-ending growth spurts.
- Small enough to fit into a backpack, easy to move from one vehicle to another
- Easy to Travel with
- Can be used in all types of vehicles
- Dynamically tested for passengers 66 – 168 lbs.
- No crotch strap included
- No Mount Needed
- One size fits most
-
Locate the tether anchor bracket.
*Check the vehicle owner’s manual to locate factory installed tether bracket.
*86Y tether strap can be turned one half twist to snap on difficult anchor locations. -
Connect tether hook to tether anchor bracket directly behind passenger.
20 degrees from “Y” center is acceptable. -
Place the Y-bridge on the seat top. Rest black shoulder straps on the front of the seat.
-
Adjust tilt lock adjuster to remove excess webbing so Y-bridge sits on seat top.
-
Place the adjustable belt straps over each shoulder of the passenger.
-
Allow the belt loop ends to lay on the passenger’s lap.
-
Thread the vehicle seat belt across the lap and through each belt loop.
-
Buckle seat belt low across the lap and reduce the seat belt clack. Make sure the seat belt in in the locked position.
-
To shorten or lengthen the shoulder vest straps slide the webbing up or down through the adjuster. Keep both adjusters as close to the shoulders as possible.
WARNING: Do not shorten the belt length too much as this could pull the lap belt up and over the stomach which might cause injury.
-
Secure the chest clip keeping the clip below the vest adjusters at arm pit level.
Washing Instructions
Cold water only. Hand or Machine wash on delicate cycle. Use a mild detergent such as woolite. Do not Machine Dry. IMPORTANT: DO NOT USE BLEACH OR DRY-CLEANING PRODUCTS.
Warranty
EZ-ON Products Stands behind the products we make. Warranty covers any defects in material or workmanships under normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.
Warning
Death or serious injury can occur if manufacturer’s instructions are not followed correctly. All EZ-ON Products are dynamically tested to meet NHTSA standards. Please follow washing instructions on product tag. Replace product if it is damaged, frayed or has been in a crash. Recommended replacement after six years. EZ-ON Products are not liable for injury if these recommendations are not followed.